Arcadian Will Be Unable to Ship Orders on Select Dates in August: Click here for more details

Best Antenna for 915 MHz LongFi Hotspot/Helium Hotspot Crypto Miners from Bobcat, Cal Chip, Nebra, RAK and Kerlink.

Posted by Michael Crudele on

We have been hearing more and more about people looking for 915 MHz LongFi Hotspot/Helium Crypto Miner Antennas for miners from Bobcat, Cal Chip, Nebra, RAK and Kerlink. After much research we have found what we believe to be the longest range antenna for these 915 MHz IoT Networking Devices (no antenna tuning required) that are "Plug n Play".

Here is what we recommend as the best Antennas & Brackets: 

Large Antennas and Brackets (24-61” tall)

 

 

The RFMAX ROSA-902-5-SNF. Medium Range 915 MHz antenna for LongFi RAH Hotspot Miner, 24” tall. This is optimum for Urban and hilly/rocky/bumpy areas.

This antenna can be mounted with the ROSA-HDM1 from RFMAX.

 

The RFMAX ROSA-902-8-SNF. Longest Range 915 MHz antenna for LongFi RAH Hotspot Miner, 61” tall. This is optimum for Rural and flat/level areas.

This antenna can be mounted with the ROSA-HDM1 from RFMAX.

 

Economy Antenna & Bracket: (only 9” tall)

 

 

The RFMAX ROSA-900-SNF. Economical 915 MHz antenna for LongFi RAH Hotspot

This antenna can be mounted with the RFMAX ROSAHDM2.

 

We also recommend connecting them back to your device using a Low Loss coax jumper cable with a Reverse Polarity SMA-Male connector on the radio end and a Standard N-Male on the Antenna end. 

Here are the links to those cables:

5 ft. Cable

10 ft. Cable

15 ft. Cable

25 ft. Cable

*Click here for more information on cable setup*

***Please note that although these antennas are DC grounded, you should be sure to protect these antennas from a lightning strike***

Our antennas can also be used for other 915MHz devices such as the Sentrius RG191 LoRaWAN Gateway. Click here to learn more! 

 

Have any questions about this product or need help picking out another mount or antenna?
 
Customer Service: customerservice@arcadianinc.com

Share this post



← Older Post Newer Post →


Leave a comment

Please note, comments must be approved before they are published.